diff --git a/drivers/net/ethernet/stmicro/stmmac/Kconfig b/drivers/net/ethernet/stmicro/stmmac/Kconfig index 67fa879b1e52..38ce9a0cfb5b 100644 --- a/drivers/net/ethernet/stmicro/stmmac/Kconfig +++ b/drivers/net/ethernet/stmicro/stmmac/Kconfig @@ -263,6 +263,18 @@ config DWMAC_SUN8I stmmac device driver. This driver is used for H3/A83T/A64 EMAC ethernet controller. +config DWMAC_SUN55I + tristate "Allwinner sun55i GMAC200 support" + default ARCH_SUNXI + depends on OF && (ARCH_SUNXI || COMPILE_TEST) + select MDIO_BUS_MUX + help + Support for Allwinner A523/T527 GMAC200 ethernet controllers. + + This selects Allwinner SoC glue layer support for the + stmmac device driver. This driver is used for A523/T527 + GMAC200 ethernet controller. + config DWMAC_THEAD tristate "T-HEAD dwmac support" depends on OF && (ARCH_THEAD || COMPILE_TEST) diff --git a/drivers/net/ethernet/stmicro/stmmac/Makefile b/drivers/net/ethernet/stmicro/stmmac/Makefile index b591d93f8503..51e068e26ce4 100644 --- a/drivers/net/ethernet/stmicro/stmmac/Makefile +++ b/drivers/net/ethernet/stmicro/stmmac/Makefile @@ -31,6 +31,7 @@ obj-$(CONFIG_DWMAC_STI) += dwmac-sti.o obj-$(CONFIG_DWMAC_STM32) += dwmac-stm32.o obj-$(CONFIG_DWMAC_SUNXI) += dwmac-sunxi.o obj-$(CONFIG_DWMAC_SUN8I) += dwmac-sun8i.o +obj-$(CONFIG_DWMAC_SUN55I) += dwmac-sun55i.o obj-$(CONFIG_DWMAC_THEAD) += dwmac-thead.o obj-$(CONFIG_DWMAC_DWC_QOS_ETH) += dwmac-dwc-qos-eth.o obj-$(CONFIG_DWMAC_INTEL_PLAT) += dwmac-intel-plat.o diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun55i.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun55i.c new file mode 100644 index 000000000000..862df173d963 --- /dev/null +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun55i.c @@ -0,0 +1,159 @@ +// SPDX-License-Identifier: GPL-2.0-only +/* + * dwmac-sun55i.c - Allwinner sun55i GMAC200 specific glue layer + * + * Copyright (C) 2025 Chen-Yu Tsai + * + * syscon parts taken from dwmac-sun8i.c, which is + * + * Copyright (C) 2017 Corentin Labbe + */ + +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include + +#include "stmmac.h" +#include "stmmac_platform.h" + +#define SYSCON_REG 0x34 + +/* RMII specific bits */ +#define SYSCON_RMII_EN BIT(13) /* 1: enable RMII (overrides EPIT) */ +/* Generic system control EMAC_CLK bits */ +#define SYSCON_ETXDC_MASK GENMASK(12, 10) +#define SYSCON_ERXDC_MASK GENMASK(9, 5) +/* EMAC PHY Interface Type */ +#define SYSCON_EPIT BIT(2) /* 1: RGMII, 0: MII */ +#define SYSCON_ETCS_MASK GENMASK(1, 0) +#define SYSCON_ETCS_MII 0x0 +#define SYSCON_ETCS_EXT_GMII 0x1 +#define SYSCON_ETCS_INT_GMII 0x2 + +static int sun55i_gmac200_set_syscon(struct device *dev, + struct plat_stmmacenet_data *plat) +{ + struct device_node *node = dev->of_node; + struct regmap *regmap; + u32 val, reg = 0; + int ret; + + regmap = syscon_regmap_lookup_by_phandle(node, "syscon"); + if (IS_ERR(regmap)) + return dev_err_probe(dev, PTR_ERR(regmap), "Unable to map syscon\n"); + + if (!of_property_read_u32(node, "tx-internal-delay-ps", &val)) { + if (val % 100) + return dev_err_probe(dev, -EINVAL, + "tx-delay must be a multiple of 100ps\n"); + val /= 100; + dev_dbg(dev, "set tx-delay to %x\n", val); + if (!FIELD_FIT(SYSCON_ETXDC_MASK, val)) + return dev_err_probe(dev, -EINVAL, + "TX clock delay exceeds maximum (%u00ps > %lu00ps)\n", + val, FIELD_MAX(SYSCON_ETXDC_MASK)); + + reg |= FIELD_PREP(SYSCON_ETXDC_MASK, val); + } + + if (!of_property_read_u32(node, "rx-internal-delay-ps", &val)) { + if (val % 100) + return dev_err_probe(dev, -EINVAL, + "rx-delay must be a multiple of 100ps\n"); + val /= 100; + dev_dbg(dev, "set rx-delay to %x\n", val); + if (!FIELD_FIT(SYSCON_ERXDC_MASK, val)) + return dev_err_probe(dev, -EINVAL, + "RX clock delay exceeds maximum (%u00ps > %lu00ps)\n", + val, FIELD_MAX(SYSCON_ERXDC_MASK)); + + reg |= FIELD_PREP(SYSCON_ERXDC_MASK, val); + } + + switch (plat->phy_interface) { + case PHY_INTERFACE_MODE_MII: + /* default */ + break; + case PHY_INTERFACE_MODE_RGMII: + case PHY_INTERFACE_MODE_RGMII_ID: + case PHY_INTERFACE_MODE_RGMII_RXID: + case PHY_INTERFACE_MODE_RGMII_TXID: + reg |= SYSCON_EPIT | SYSCON_ETCS_INT_GMII; + break; + case PHY_INTERFACE_MODE_RMII: + reg |= SYSCON_RMII_EN; + break; + default: + return dev_err_probe(dev, -EINVAL, "Unsupported interface mode: %s", + phy_modes(plat->phy_interface)); + } + + ret = regmap_write(regmap, SYSCON_REG, reg); + if (ret < 0) + return dev_err_probe(dev, ret, "Failed to write to syscon\n"); + + return 0; +} + +static int sun55i_gmac200_probe(struct platform_device *pdev) +{ + struct plat_stmmacenet_data *plat_dat; + struct stmmac_resources stmmac_res; + struct device *dev = &pdev->dev; + struct clk *clk; + int ret; + + ret = stmmac_get_platform_resources(pdev, &stmmac_res); + if (ret) + return ret; + + plat_dat = devm_stmmac_probe_config_dt(pdev, stmmac_res.mac); + if (IS_ERR(plat_dat)) + return PTR_ERR(plat_dat); + + /* BSP disables it */ + plat_dat->flags |= STMMAC_FLAG_SPH_DISABLE; + plat_dat->host_dma_width = 32; + + ret = sun55i_gmac200_set_syscon(dev, plat_dat); + if (ret) + return ret; + + clk = devm_clk_get_enabled(dev, "mbus"); + if (IS_ERR(clk)) + return dev_err_probe(dev, PTR_ERR(clk), + "Failed to get or enable MBUS clock\n"); + + ret = devm_regulator_get_enable_optional(dev, "phy"); + if (ret) + return dev_err_probe(dev, ret, "Failed to get or enable PHY supply\n"); + + return devm_stmmac_pltfr_probe(pdev, plat_dat, &stmmac_res); +} + +static const struct of_device_id sun55i_gmac200_match[] = { + { .compatible = "allwinner,sun55i-a523-gmac200" }, + { } +}; +MODULE_DEVICE_TABLE(of, sun55i_gmac200_match); + +static struct platform_driver sun55i_gmac200_driver = { + .probe = sun55i_gmac200_probe, + .driver = { + .name = "dwmac-sun55i", + .pm = &stmmac_pltfr_pm_ops, + .of_match_table = sun55i_gmac200_match, + }, +}; +module_platform_driver(sun55i_gmac200_driver); + +MODULE_AUTHOR("Chen-Yu Tsai "); +MODULE_DESCRIPTION("Allwinner sun55i GMAC200 specific glue layer"); +MODULE_LICENSE("GPL");